|
Spindle Error Analysis System
1 S.E.A. Data Acquisition System, including:
5 CPL290 Drivers, TMP190 Temperature
Sensor Module, 7 Temperature Sensors, Enclosure
5 Capacitance Probes C1-C; 0.0008-0.025" range
1 Dual Master Ball; 1" diameter
1 Calibration Fixture
1 Three Probe Nest
1 Five Probe Nest
1 PCMCIA Data Acquisition Card
1 Advanced Spindle Error Analyzer Software ver.
8.0 & Training DVD
1 Travel Case
-
Fast results
-
Accurate response
-
Increased production
The Spindle Error Analyzer measures and analyzes real time geometry of machine tool spindles using capacitance gages. Capacitance gaging
allows measuring equipment to be readily calibrated and traceable to a national standard. With the Spindle Error Analyzer, spindles are analyzed
according to ANSI/ASME B5.54. Capacitance gaging is insensitive to all metal alloy variations, is not affected by variations in target surface texture,
and gives accurate results.
Spindle thermal problems can also be readily identified, isolated, and corrected. Spindle warm up time can be determined, increasing productivity.
Axial and radial problems which contribute to surface finish problems can be identified.
Locus™ eM (purchased separately) enhances the Lion Spindle Analysis Software by documenting setup instructions
with text or graphics. Locus eM Drift Test
feature can be used with the Lion software to perform 5-Gage Drift (TVE)
Analysis. Temperature Variation Errors including Spindle Tilt are easily measured
and documented.
Note: Measurement of Lathe spindles requires an additional Lathe Adapter (P/N IQL-1100-451)
for Probe Nest Mounting.
Request a Quote
 IQL is an authorized reseller of
Lion Precision calibration instruments. With years of industry experience,
IQL provides technical expertise with all products.
|
